IMPLEMENTASI KENDALI PID PENALAAN ZIEGLER-NICHOLS MENGGUNAKAN MIKROKONTROLER
Abstract
PID control has been widely used in industry as well as been implemented in the control of the liquid level . The research objective is to design PID controller base on microcontroller and then apply it on the miniature hopper-conveyor plant to maintain solid levels of raw materials to remain constant . The dimension of hopper is 25 cm long, 20 cm wide and 25 cm high.
The design of PID control uses a separate action based on microcontroller and for the tuning uses open-loop Ziegler-Nichols. The design is implemented in miniature hopper-conveyor plant to move the raw material form of green beans to the hopper using a screw conveyor. The screw conveyor is rotated by a three phase induction motor with inverter speed drive. Level in the hopper is measured by using an ultrasonic sensor module build-in the data acquisition program .
The experimental results of implementation on the miniature hopper-conveyor plant shows that PID control provides good performance such as overshoot occurs in 1 cm, or 0.05 % of set point and risetime shows 280 seconds.
Key words: PID controller, microcontroller, Ziegler-Nichols, Hopper-conveyor plant
Full Text:
PDFDOI: https://doi.org/10.30873/ji.v15i1.410
Jurnal Informatika is abstracting and indexing in the following databases:
JURNAL INFORMATIKA
Dikelola Oleh: Lembaga Penelitian dan Pengabdian kepada Masyarakat (LPPM)
Diterbitkan Oleh: Institut Informatika dan Bisnis Darmajaya
Alamat: Jl. Z.A. Pagar Alam No. 93 Gedong Meneng, Bandar Lampung Lampung
Website: jurnal.darmajaya.ac.id
Email: lp4mjurin@gmail.com
Jurnal Informatika is licensed under a Creative Commons Attribution 4.0 International License.